Plasma cutting equipment
Go back to the catalogPOWER SOURCES FOR PLASMA CUTTING
| Supply voltage | 220 (+10%,-15%) |
| Current control range, А | 35-70 |
| Load duration, % ( with filter, %) | 80 (65) |
| Maximum thickness of metal | 20 mm |
| Weight, кg | 11 |
| Supply voltage | 380 (+10%,-15%) |
| Current control range, А | 35-120 |
| Load duration, % ( with filter, %) | 60 (40) |
| Maximum thickness of metal | 40 mm |
| Weight, кg | 24 |
| Supply voltage | 380 (+10%,-15%) |
| Current control range, А | 35-140 |
| Load duration, % ( with filter, %) | 60 (40) |
| Maximum thickness of metal | 50 mm |
| Weight, кg | 24 |
| Supply voltage | 380 (+10%,-15%) |
| Current control range, А | 35-140 |
| Load duration, % ( with filter, %) | 100 |
| Maximum thickness of metal | 50 mm |
| Weight, кg | 43 |
| Supply voltage | 380 (+10%,-15%) |
| Current control range, А | 30-105 |
| Load duration, % ( with filter, %) | 100 |
| Maximum thickness of metal | 35 mm in automatic mode |
| Weight, кg | 43 |
Equipment for plasma cutting
If you cut the metal sheets on a regular base, then will make sense to purchase this cutting equipment. The price ranges greatly, but we can guarantee that our equipment has very competitive pricing.
The equipment functions in the way that the gas gets ionized by means of an electric arc and heated up to high temperatures (within 30 thousand degrees). The obtained plasma has an exceptionally high electrical conductivity. This method allows you to handle any metal conducting current, faster, better, easier, without the use of gas cylinders and special additives.
Plasma cutting machines effectively treat both nonferrous and ferrous materials (copper, aluminum, steel, cast iron or even titanium).
The accuracy and quality are equally good, the incisions are minimal, so additional processing is not required. It takes a short time to burn, therefore, you have better output of the finished products, and there is no overheating of the workpiece, therefore, the structure is not broken. This equipment is economical and does not pollute the environment.
There is also a multifunctional complex with plasma and gas torches on different calipers that can be applied in various cases. Depending on the gas-cutting torch used, the thickness of the metal being cut is different. The conventional cutters don’t not exceed 100 mm, but it is possible to install a plasma cutting torch and cut metal sheets of 300 mm thick.
There are limitations on the number of connected devices, for example, only one cutter can be connected to a plasma torch. Units with a built-in compressor are usually made compact and hand-held, therefore they do not provide high power. However, such devices are mobile, and our products are able to function at temperatures up to - 40 C. All our equipment has changeable dust filters that keep the dust off the inner parts of the equipment. The dust filters prolongs the service life of the equipment, and allow to use our equipment in an aggressive, dusty and humid environment.
You can choose the relevant equipment on our web site that will meet your quality requirements.